LAN Web UI 报错 missing scope: operator.read：复现、回退与作用域核验流程

问题/场景：升级 2026.2.14 后，通过服务器 IP 访问 Web UI 出现 `missing scope: operator.read`，localhost 正常。前置条件：gateway.bind=lan 且需要远程 Web UI。实施步骤：先做 LAN/localhost 对照复现，再按社区路径进行版本回退与 token/scope 复核。关键命令：`openclaw status`、`openclaw gateway status`、`openclaw logs --follow`。验证：LAN Web UI 菜单可正常加载。风险：若只重启不处理版本/令牌冲突，问题可能复发。

GITHUBDiscovered 2026-02-16Author ngocchudragon

Prerequisites

OpenClaw is running with LAN bind and Web UI is accessed via server IP/domain.
You can capture logs and perform version rollback if needed.

Steps

Compare two paths: access Web UI via LAN IP and via localhost/127.0.0.1, and confirm only LAN path fails with `operator.read`.
Collect baseline diagnostics (`openclaw status`, `openclaw gateway status`, `openclaw logs --follow`).
Apply temporary rollback to last known good version in your environment, then restart gateway and retest LAN Web UI.
Before re-upgrade, validate token/scope mapping for LAN clients and verify permissions are not overridden by explicit token precedence changes.

Commands

openclaw status

openclaw gateway status

openclaw logs --follow

Verify

When opening Web UI via LAN IP, overview and operator-dependent pages load without scope errors.

Caveats

Issue thread confirms symptom broadly but not one-click permanent fix yet; treat workflow as troubleshooting runbook（需验证）.
If multiple auth methods coexist, stale credentials can mask root cause during testing.

Source attribution

This tip is aggregated from community/public sources and preserved with attribution.

Open original source ↗

Visit original post